Build instructions

I would recommend that you print these in batches of 3pcs. Check the length of one piece, so if your printer cannot achieve 3pcs in a print, you might have to print two or even one per batch diagonally. Very small amount of supports is necessary here, so keep a close eye on tutorials.

Build process

Files

1. curve-left-track.zip

Important notes

• PETG recommended
• pay close attention to adhesion on the build plate - make sure you are not printing over some logos or anything else on your buildplate
• do not place more supports than necessary
• no brim

The tutorial below is the same for plain tracks (straight, curved etc..)

Slice the tracks