Build instructions

I would recommend that you print these in batches of 3pcs. The length of one piece is 205mm, so if your printer cannot achieve that, you might have to print two or even one per batch diagonally. Very small amount of supports is necessary here, so keep a close eye on tutorials.

Build process

Files

1. straight-track.zip

Important notes

• PETG recommended
• pay close attention to adhesion on the build plate - make sure you are not printing over some logos or anything else on your buildplate
• do not place more supports than necessary
• no brim

The tutorial below is the same for plain tracks (straight, curved etc..)

Slice the tracks