Description Tools & materials Instructions

Tools and materials

Preferrably printed out of PETG, this print doesn't require any other tools or materials out of the ordinary 3D printing set of tools. So you just slice, print, remove supports and perhaps trim the edges a bit with a scalpel if you printbed is too close to the nozzle.

Build instructions

I would recommend that you print these in batches of 3pcs. The length of one piece is 205mm, so if your printer cannot achieve that, you might have to print two or even one per batch diagonally. Very small amount of supports is necessary here, so keep a close eye on tutorials.

Build process

Files

straight-track.zip

Important notes

PETG recommended
pay close attention to adhesion on the build plate - make sure you are not printing over some logos or anything else on your buildplate
do not place more supports than necessary
no brim

The tutorial below is the same for plain tracks (straight, curved etc..)

Slice the tracks